MPM MOD-22 Bedienungsanleitung Seite 29

- With regard to vacuum cleaner's case made from artificial ma-
terials, keep the device far from all sources of warmth (radiators,
heaters etc.)
- Do not block inlets or outlets of the vacuum cleaner
- After each use the container should be emptied, cleaned and
dried. To dry the interior of tubes and hose, the device should
suck in dry air for a while. This allows avoiding an unpleasant
smell and scent.
- When dry vacuum cleaning with the water filter head, do not
use the vacuum cleaner without water.
- Do not vacuum people or pets, and take particular care not to
bring the nozzle close to your eyes or ears.
- Do not vacuum without filters or if they are damaged.
- Do not hold or connect the device with wet hands.
- Check the suction hose, pipes and nozzles – remove debris inside.
- Move the vacuum cleaner carefully over thresholds and other
uneven surfaces so as not to cause excessive movement of the
water in the tank. This could cause a small amount of water to
be ejected outside the unit.
- Do not allow the vacuum cleaner to overturn or flood with water
during operation.
- Always ensure that all parts of the appliance are correctly fitted
before starting work.
- Do not use the device for purposes other than those for which
it was intended.
- Switch off the vacuum cleaner before replacing equipment.
- The equipment is not designed to operate using external timers
or a separate remote control.
- Do not use the pump when the liquid tank is empty or when
you are not using the wash or wet cleaning functions. This may
result in its aeration. If the pump is switched on without water,
it will start to heat up, the automatic safety system will cut off
the power supply to the pump. The pump will not be able to
start until it has cooled down.
- The vacuum cleaner is designed for home use only.
- Do not use the appliance outdoors.
EN
29