MPM MOD-22 Bedienungsanleitung Seite 32

EN
E9 – Sucking tubes (2)
E10 – Slider lock lever dispenser
F. Washing tip. It is used for sucking liquids from carpets, rugs and floors. This attachment
also sprays a washing liquid. In case of hard floor surfaces the washing tip must be used
together with an attachment.
F1 – Washing tip.
F2 – Attachment for hard surfaces.
G. Tip for delicate wet washing. This tip is suitable for cleaning furniture upholstery, cur-
tains etc. and for sucking liquid from narrow areas.
G1 – Tip
H. Additional accessories.
H1 – Carpet and floor hand
H2 – Air refresher
H3 – Shampoo
H4 – Anti-foaming agent
H5 – Narrow attachment
H6 – Turbo brush
H7 - Integrated brush
H8 - Crevice tool handle / docking station clip
BEFORE FIRST USE
1. Remove the appliance from the box. Remove all plastic sheets, bags and styrofoam inserts.
2. During unpacking check if there are all parts and if they are not damaged.
3. Make sure that your mains power supply corresponds to the voltage stated on the rating plate.
APPLIANCE ASSEMBLY (PIC. 2)
1. Disconnect a short washing hose (C2), located between washing liquid container (C1) and engine's
set and carefully take it from the connector (PIC. 2.1, 2.2).
2. Disengage the clamps (B6) (PIC. 2.3). Lift an engine's set with the use of fixed handle and take water
filter element off (B2).
3. Release locks (D3) from the base and lift water filter container (B1) and washing liquid tank (C1)
(PIC. 2.3).
4. Mount the wheels (D2) on the underside of the base (D1) if they have not been mounted already.
5. Make sure that a foam filter (A8) is fixed in a float chamber (A7) (PIC. 2.4).
6. Fix a water filter tube (B4) (PIC. 2.8), through a rubber gasket (B5) (PIC. 2.9).
7. Put washing liquid tank (C1) on a base (D1), fix the water filter container (B1) and block the locks
(D3).
8. Within the head (B2), install the water filter sponges (B3) and 2 pieces of rubber plugs (B9) on the
tabs with holes, on the lower part of the water body (B2) fig.18.
9. Next put the water filter tank (B2) on the water container (B1) (PIC. 2.11).
10. Put engine's set on the container and fix using clamps (B6).
11. To fix the sucking hose (E5), put a fastening element (E1) to sucking inlet (B8).
32