Kobra CYCLONE Betriebsanleitung Seite 36

7 MAINTENANCE
KOBRA CYCLONE is a simple and easy to use machine.
The Cyclone does not need any oiling or lubrication of the
cutting blades. The Cyclone does not need any service or
maintenance except that:
- filter bag should be checked regularly and replaced
when full;
- the plastic waste bag level should be checked
regularly even If an automatic sensor controls its
level;
- sharpening of the cutting blades should be checked
regularly.
Mantaining cutting blades sharpened allows a more
efficient shredding action and reduces the time required
to complete the shredding of the material. To change
cutting blades see paragraph 8.1.
8 REPLACEMENT OF PARTS AND
MAIN SERVICE OPERATIONS
8.1 HOW TO CHANGE THE CUTTING
BLADES
DISCONNECT the Cyclone from main power supply by
•
turning the main switch (U) [Fig.11] into "0" position
and disconnect the plug of the power cord from main
power supply.
Open lock with the standard key and remove plastic
•
side cover (M) [Fig.8].
Open door of the shredding chamber and make sure
•
that the inside of the chamber is well illuminated
(a battery operated lamp can be inserted into the
shredding chamber).
Loose and remove the nut on top of the blades and
•
start removing each blade from its housing.
Replace blades by following the correct mounting
•
sequence and the position of the sharpened edges as
shown in the following picture.
BLADES CAN BE RE-SHARPENED BY QUALIFIED
SERVICE PEOPLE.
KOBRA Cyclone
8.2 HOW TO CHANGE THE SECURITY
LEVEL (How to change the screen)
DISCONNECT the Cyclone from main power supply
•
and follow the steps of paragraph 8.2.
After blades have been removed loose and remove
•
through a 4 mm hexagon key each fixing screw (2) of
the metal Screen.
Remove the screen from its position and install
•
the new desired screen by aligning the holes of the
screen with the correspondent holes of the screen
housing in the machine.
Install blades in their final position by following
•
correctly the mounting sequence and the position of
the sharpened edges.
8.3 HOW TO REPLACE THE TURBINE
MAIN MOTOR
This is a service operation which should be performed
by qualified people in case of failure of the main turbine
motor.
DISCONNECT the Cyclone from main power supply by
•
turning the main switch (U) [Fig.11] into "0" position
and disconnect the plug of the power cord from main
power supply. Follow the steps of paragraph 8.1 and
8.2.
After the last step of paragraph 8.2 remove main
•
turbine metal shaft (1) by loosing the fixing screw (2)
on the same turbine shaft.
34
1
DI-129/13/14.04.2022