Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Maintenance and cleaning
WARNING! RISK OF INJURY!
Disconnect the tool from the compressed air supply.
CAUTION!
►
Before maintenance, clean off any hazardous substances that
may have accumulated on the tool (due to working processes).
Avoid all skin contact with these substances. If the skin comes
into contact with hazardous dusts, this can lead to severe
dermatitis. If dust is produced or swirled up during
maintenance, it can be inhaled.
NOTE
►
To ensure correct functioning and a long service life for the
tool, pay attention to the following points:
■
Sufficient and continuous oil lubrication is highly important for
optimum functioning.
■
Check the speed and vibration levels after each use.
■
Check the idle speed regularly and after any maintenance is
performed: use a rev counter and perform the measurement
without any clamped tools. At a residual pressure of 6.3 bar, the
idle speed may not be exceeded under any circumstances.
■
If the tool is exhibiting excessive vibration levels, the cause of the
vibrations must be identified and repaired.
■
Use only the genuine replacement parts recommended by the
manufacturer, otherwise you could put users at risk. In doubt,
contact the Service Centre.
■
Clean the tool with a soft, dry cloth only.
■
Never use sharp or abrasive cleaning agents under any
circumstances.
│
GB │ IE
■
48
PDSS 16 A1
Werbung
