Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Hazards caused by accessories
■
Separate the compressed air tool from the compressed air supply
before replacing the attachment or accessory.
■
Only use accessories that are intended for this appliance and
comply with the requirements and specifications listed in these
operating instructions.
■
Avoid direct contact with the accessory tool during and after use
because it may be hot or have sharp edges.
■
The permissible speed of the accessory tool used must be at least
as high as the maximum speed specified for the compressed air
tool. Accessories that rotate faster than the permissible rate can
break and throw pieces into the air.
■
Never fit a grinding disc, cutting disc or milling cutter. A bursting
grinding disc can lead to serious injuries or death.
■
Do not use discs that are damaged, cracked or have been
dropped.
■
Only approved accessory tools with the appropriate shaft
diameter may be used.
■
Observe the manufacturer's recommendation for small grinding
tools. The maximum permissible protrusion (L0 = length of the
shaft between the collet chuck end and the small grinding tool)
specified by the manufacturer must not be exceeded when using
small grinding tools! If the protrusion (L0) is increased, the
permissible rotation speed must be lowered. Wherever possible,
insert the complete length of the shaft of the accessory tool into
the collet chuck. Ensure that the clamping length (Lg) is at least
10 mm.
PDSS 16 A1
GB │ IE
│
39
■
Werbung
