Parkside PZM 2 B3 Bedienungs- Und Sicherheitshinweise Seite 69

˜ Relative mode
NOTE: Selecting the relative
mode causes the product to
store the present reading as
a reference for subsequent
measurements .
1 . Set the product to the desired
measurement mode .
2 . Connect the product to a desired
circuit (or object) to obtain a
reading . This reading will then
be used as a reference for
subsequent measurements .
3 . Press REL
the relative mode . The current
reading is stored in the memory .
0 and
–
REL
–
are shown in the display
NOTE: The product cannot
enter the relative mode if OL
("over range") is shown in the
display
4 . In subsequent measurements,
the difference between the
stored reference and the new
measurement is shown in the
display
5 . Exit relative mode:
Press REL
–
REL
–
display
. The product enters
11 ] [
[ 16 ]
.
6 ] [
.
6 ] [
again .
11 ] [
goes off in the
[ 16 ]
.
6 ] [
.
[ 6 ]
GB/IE 69