Westfalia 85 46 55 Originalanleitung Seite 29

5. First push the table horizontally against the sanding dish and
then vertically upwards. For tightening the dish use both lock
handles (66). Tighten the locking handles into the disc end
shield through both guide slots that
are situated on the table.
6. Position the sanding table to the
required angle to the dish and
tighten the two locking handles.
One accessory is a mitre gauge (62).
Whenever you intend to make double
mitre section, use the mitre gauge.
Adjust the required angle and place the
mitre joint pole (63) of the mitre gauge
into the groove of the sanding disc table.
Switching ON/OFF the Belt and Disc Sander
1. Make sure that the mains power in your area corresponds
with the type labelled on the machine.
2. To switch on the machine press the ON switch
switching off press the OFF switch O .
This machine is equipped with a safety switch that contains a low
voltage circuit breaker. This avoids unintentionally starting up the
machine.
Dust Collection System
For dust collection two adapters are provided with the belt and
disc sander.
1. Use the dust collection whenever possible.
2. If no dust collection system or vacuum cleaner is available
while sanding, protect yourself by wearing a dust mask.
Operation
25
Dust Collection
Adaptors
I and for