Operation; Before Getting Started; Switching The Appliance On And Off; Setting The Temperature - hanseatic HSBS17590CWEI Gebrauchsanleitung

Page EN-18

Operation

Operation

Before getting started

• Read chapter „Safety" from page EN-4
and all the safety notices.
• Set up and connect the appliance as
described in chapter „Start-up" from
page EN-12.
Switching the appliance on
and off
NOTICE
Risk of damage!
If the cooling appliance has been trans-
ported horizontally, lubricant from the
compressor may get into the cooling
circuit.
■ Allow the appliance to stand upright
for approx. 2 hours after transport
and before connecting.
Switching on
The appliance is switched on as soon as the
mains plug is plugged in.
The compressor starts to work, the refrigerant
flows through the pipes and a quiet humming
sound can be heard.
The symbols on the control panel illuminate
for 3 seconds.
If the appliance makes unusual noises,
check that it is on a solid base and re-
move any objects that are on top of the
appliance.
Switching off
• To switch the appliance off, pull the mains
plug out of the socket.
When the appliance is switched off,
leave the appliance doors open slight-
ly to prevent mould from forming.

Setting the temperature

CAUTION
Health hazard!
The appliance may not operate proper-
ly if the ambient temperature exceeds
or falls below the specifi ed temperature
range for a prolonged period. This can
then lead to an increase in temperature
inside the appliance.
■ Always ensure the prescribed ambi-
ent temperature is maintained (see
„Intended use" on page EN-4).
If you set a lower temperature, you will
require greater refrigeration perfor-
mance. This increases energy con-
sumption.
Switching on for the first time
When the appliance is switched on the first
time, the standard temperature setting is
+5 °C for the fridge and -18 °C for the freezer.
All symbols on the display will also illuminate
for a couple of seconds; the control panel is
locked.
Locking and unlocking the control
panel
• To unlock the control panel, press the
MODE SELECT button (25) for 3 sec-
onds. The 'Button lock' (26) indicator will
disappear, a beep will sound and the con-
trol panel will unlock.
• To lock the control panel, press the MODE
SELECT button (25) for 3 seconds.