Herunterladen Diese Seite drucken

Mitsubishi Electric Mr.SLIM SEZ-M25DA2 Installationshandbuch Seite 24

Vorschau ausblenden Andere Handbücher für Mr.SLIM SEZ-M25DA2:

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 25
9. Test run
See the table below for the details of the LED display (LED 1, 2, and 3) on the indoor controller board.
LED 1 (microcomputer power supply)
LED 2 (remote controller power supply)
LED 3 (indoor/outdoor unit communication)
Note:
If the unit is operated continuously during a test run, the unit stops after 2 hours.
9.3. Self check
Refer to the installation manual that comes with each remote controller.
10. System control
Refer to the outdoor unit installation manual.
11. Easy maintenance function
Maintenance data, such as the indoor/outdoor unit's heat exchanger temperature and compressor operation current can be displayed with "smooth maintenance".
* This cannot be executed during test operation.
* Depending on the combination with the outdoor unit, this may not be supported by some models.
[Fig. 11-1] (P.10)
• Select "Service" from the Main menu, and press the [ SELECT] button.
• Select "Check" with the [ F1] or [ F2] button, and press the [ SELECT] button.
• Select "Smooth maintenance" with the [ F1] or [ F2] button, and press the [ SELECT] button.
[Fig. 11-2] (P.10)
Select each item.
• Select the item to be changed with the [ F1] or [ F2] button.
• Select the required setting with the [ F3] or [ F4] button.
"Ref. address" setting .......... "0" - "15"
"Stable mode" setting........... "Cool" / "Heat" / "Normal"
• Press the [SELECT] button, fixed operation will start.
* Stable mode will take approx. 20 minutes.
[Fig. 11-3] (P.10)
The operation data will appear.
The Compressor-Accumulated operating (COMP. run) time is 10-hour unit, and the Compressor-Number of operation times (COMP. On/Off) is a 100-time unit (fractions
discarded)
Navigating through the screens
• To go back to the Main menu................[ MENU] button
• To return to the previous screen........... [ RETURN] button
24
Indicates whether control power is supplied. Make sure that this LED is always lit.
Indicates whether power is supplied to the wired remote controller. The LED is lit only for the indoor unit that is
connected to the outdoor unit that has an address of 0.
Indicates whether the indoor and outdoor units are communicating. Make sure that this LED is always blinking.

Werbung

loading