Change Of Crystal - Reely Sky Hawk Bedienungsanleitung



13. Change of crystal

In order to avoid a double channel assignment it may be necessary to change the crystals on your remote control
system.
For reasons of operational safety, you should only use crystals that are explicitly recommended for the
use of your remote control system by the supplier.
For this purpose, proceed as follows:
• While the transmitter is switched off, remove the holder for the transmitter quartz from the transmitter housing (see
ill. 2, pos. 8).
• Take the transmitter crystal out of its plastic holder. Insert the replacement crystal with a different channel in the
same frequency band. Please make sure that you place the right crystal in the holder. Transmitter crystals are
normally marked with the letter T or TX (T = "transmitter"). Put the crystal holder back into the transmitter.
• When the flight battery is disconnected pull the receiver
crystal (1) from the receiver (2).
• The suitable crystal for the receiver has to be marked
with the same channel number as the transmitter crystal.
In addition it is marked with the letter code R or RX (R =
receiver).
• Insert the replacement crystal with the suitable
frequency for the transmitter into the receiver.
• Switch on the transmitter and afterwards the receiver
and check the function of the system.
Figure 19
57