Stahl 9496/35-Serie Betriebsanleitung Seite 34

Cleaning
EN
10 Cleaning
EN
 Check the device for damage before and after cleaning it. Take damaged devices out of
EN
operation immediately.
 To avoid electrostatic charging, the devices located in hazardous areas may only be
EN
cleaned using a damp cloth. Do not clean the PCB with the plug connectors.
EN
 When cleaning with a damp cloth, use water or mild, non-abrasive, non-scratching
EN
cleaning agents.
 Do not use corrosive cleaning agents or solvents.
EN
 Never clean the device with a strong water jet, e.g. using a pressure washer.
EN
EN
11 Disposal
EN
 Observe national and local regulations and statutory regulations regarding disposal.
EN
 Separate materials when sending them for recycling.
EN  Ensure environmentally friendly disposal of all components according to the statutory
regulations.
EN
EN
12 Accessories and Spare parts
EN
EN
NOTICE! Malfunction or damage to the device due to the use of non-original components.
Non-compliance can result in material damage.
EN
 Use only original accessories and spare parts from R. STAHL Schaltgeräte GmbH
EN
(see data sheet).
EN
EN
EN
EN
EN
EN
EN
14
Base for CPU and power modules, Zone 2
Series 9496/35
262395 / 949660310010
2017-11-07·BA00·III·en·00