Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The timer must be set as follows for automatic operation:
Ensure that the main switch has been turned to the OFF
position.
Loosen the plastic screws in the two left corners.
Open the housing cover.
Adjust the time switch in accordance with the illustration
at the side:
Select the desired operating times by tuning the run-
ning wheel.
Select the desired time slots by latching to the left.
Synchronise the current time at the triangle.
Select operating mode (I=Continuous operation,
=Timed operation, 0=Permanently off).
Check whether the desired operating mode has been
selected.
By sliding the latching piece to the left, a 15 minute
time interval is set to "ON". All of the latching pieces
remaining in the right position are "OFF".
Close the housing cover and tighten the plastic screws.
Set the main switch to the ON position and restart the
system.
Check the automatic mode function.
Menu texts for auger screw
0
System info
016-141_01
Installation and operating instructions
71 / 92
Werbung
