Cleaning The Appliance; Cleaning Surfaces; Cleaning The Jug; Cleaning The Grinder - Melitta AromaFresh Therm Pro Bedienungsanleitung

8 Cleaning the appliance

Regular cleaning and maintenance of the appli-
ance guarantee the consistent high quality of
your coffee.
Always allow the appliance to cool down
before cleaning it.
Attention! Unsuitable cleaning agents can
damage the appliance. Only use the recom-
mended cleaning agents.

8.1 Cleaning surfaces

Use a soft, damp cloth to clean the surfaces.
Remove external soiling immediately.
You can remove residue from the coffee
beans in the bean container with a soft cloth.
The cloth needs to be dry.

8.2 Cleaning the jug

Rinse the jug, the lid and the filter insert with
clear, warm water and a small quantity of
washing up liquid. Clean the outer surfaces of
the jug with a soft, moist cloth.

8.3 Cleaning the grinder

Clean the grinder if you see visible soiling.
After each time you clean the grinder, you
should also clean the ground coffee chute, see
section 8.4 Cleaning the ground coffee chute on
page 22.
You can also watch a video of the
cleaning steps. To do this, simply
use the adjacent QR code.
Disassembling and cleaning the grinding
fineness regulator
1. Empty the bean container.
2. Allow the grinder to grind itself empty.
Do this by fitting a filter in the filter insert
and starting the grinding process with the
"Start/Stop" button.
» The appliance indicates that there are no
coffee beans in the bean container.
3. Turn the grinding fineness regulator until
the two triangles point towards each other.
4. Pull the grinding fineness regulator verti-
cally upwards out of the appliance.
5. Disassemble the grinding fineness regulator
as shown in the following picture.
To loosen the grinding ring (25),
turn it to the position shown.
6. Clean all parts of the grinder with the
brush.
You can remove the ground coffee from
the grinding ring by knocking it lightly. You
can also remove the ground coffee with a
vacuum cleaner.
If it is heavily soiled, you can clean the
grinding ring under running water. Allow
the grinding ring to dry completely.
7. Clean the lower grinding disc (28), the
gap (26) and the entrance to the ground
coffee chute (27). You can remove loose
ground coffee with a vacuum cleaner.
Loosen caked-on ground coffee with the
brush.
Cleaning the appliance
23
24
25
21