Before using for the first time
General information
• Only use pure water without
carbonation.
• Use the supplied test strip to determine
the hardness of the water used and set
the water hardness („Water hardness
and filter", Seite 18).
Information for using for the first
time
The appliance must be vented before
it is used for the first time. To do so,
the appliance may only be switched on
without a Melitta
with a completely filled water reservoir.
• Place a vessel under outlet 2.
• Press the
appliance.
• Press the
pumped through the system.
• The appliance is ready for operation
when
• After using the appliance for the first
time, insert the Melitta
filter if required (see page 19).
Downloaded from
www.Manualslib.com
Claris
water filter and
®
®
button to switch on the
illuminates on the display.
button. Water will be
illuminates on display 9.
Claris
water
®
®
manuals search engine
Starting up the appliance
Starting up
Warning!
Danger of fire and electric shock
due to incorrect supply voltage,
incorrect or damaged connections
and power cable.
– Ensure that the supply voltage
corresponds to the supply voltage
specified on the identification label of
the appliance. The identification label is
located on the right side of the appliance
behind the cover (Image A, 11).
– Make sure that the power socket meets
the applicable standards for electrical
safety. If in doubt, contact a qualified
electrician.
– Never use damaged power cables
(damaged insulation, bare wires).
• Place the appliance on a stable, dry and
level surface with sufficient clearance (at
least 10 cm) to the sides.
• Plug the power cable into a suitable
power socket.
• Remove the lid from the bean container
7.
• Fill the bean container with suitable
coffee beans.
• Put the lid back on.
• Raise the lid of the water reservoir 6 and
pull the water reservoir up and out of the
appliance.
• Fill the water reservoir with fresh tap
water only up to the max. mark.
17