Setting The Water Hardness - Melitta Caffeo Solo Bedienungsanleitung

Inserting the water filter
flashes during the entire changing
process.
• Put the water filter in a glass with
tap water for several minutes before
inserting it in the appliance.
• Switch off the appliance.
• Press and hold the
for ca. 3 seconds, then release.
appears on the display.
• Empty and insert the drip tray.
illuminates.
• Pull the water reservoir 6 up and out of
the appliance.
• Empty the water reservoir.
• Screw the water filter onto the thread at
the bottom of the water reservoir.
• Fill the water reservoir with fresh tap
water up to the max. mark.
• Insert the water reservoir into the
appliance.
• Press the
performs an automatic rinse. When
rinsing is finished, the appliance is ready
for operation and the water hardness is
set to hardness level 1.
• Empty and insert the drip tray.
After inserting the water filter, the water
can be cloudy during the first rinse
because excess activated carbon is
washed out of the filter. The water then
becomes clear again.
Downloaded from www.Manualslib.com
and buttons
button. The appliance
manuals search engine

Setting the water hardness

The appliance includes a test strip to
determine the water hardness.
• Determine the hardness of the tap water
using the test strip.
• Switch on the appliance.
• Press the and
simultaneously for longer than 2
seconds. flashes rapidly.
• Press the button to show the menu
for setting the water hardness.
illuminates.
• Set the determined water hardness by
pressing the button. The selected
water hardness is shown by the bean
symbols .
Water hardness
1:
2:
3:
4: flashing
• Press to confirm the selection.
button
°d °e °f
0 - 1 0 0 - 1 3 0 - 1 8
10 - 1 5 13 - 1 9 18-27
15 - 2 0 19 - 2 5 27-36
> 20 > 25 > 36
19