Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
• Attention! Hazard of burns: During operation the jug becomes hot! Always touch
the appliance at the handle for pouring out and transportation!
• Attention: There is the hazard of burns with hot liquids!
• The appliance is equipped with a heating element. Therefore, it is not necessary to heat the milk before
preparation.
• To make stable and fine-pored milk foam, we recommend using cooled milk with a fat content of 1.5 %.
• After preparing milk foam, a rest of liquid milk remains in the jug. This is normal – we recommend using
this milk for your beverage.
• Let the appliance cool down between 2 operations to avoid that milk will stick to the bottom of the jug.
Preparation
• Grasp the jug at the handle and remove it from the base station!
• Unwind the power cord from the cord take-up and plug in the appliance.
• Open the lid (observe the 90°-position).
• Fill the jug (observe the min. and max. capacity at the inside of the jug!).
• Attach the stirrer to the drive axle.
for frothing:
serrated stirrer
(max. filling 200 ml)
• Afterwards close the lid and press it on firmly.
• Grasp the jug at the handle and position it on the base station.
Application
• Switch on the appliance.
FUNCTION 1: Warm frothing/stirring, e. g. milk (ca. 60 °C)
NOTE: The preparation may also be interrupted at any time by pressing the left half of the function switch
again or by grasping the jug at the handle and removing it from the base station. The pilot lamp extingu-
ishes.
FUNCTION 2: Re-frothing/re-stirring of warm milk foam/liquids
Upon completion of function 1, the function "re-frothing/re-stirring" can be activated in order to refine the
result – the heating is not active.
"Re-frothing/re-stirring" only works if the function "re-frothing/re-stirring" is activated directly after
completion of function 1 and if function 1 has not been interrupted.
• Press the left half
• The appliance starts the preparation, the heating is active.
• The pilot lamp glows red.
• The appliance switches off automatically after ca. 2 – 3 minutes
depending on the filling quantity.
• The pilot lamp extinguishes.
for stirring:
non-serrated stirrer
(max. filling 250 ml)
of the function switch.
17
Werbung
Inhaltsverzeichnis
