Herunterladen Inhalt Inhalt Diese Seite drucken

Warranty And Liability; Organizational Measures - TR-Electronic LMRS 27 500 Gesamt-Bedienungsanleitung

Linear encoder magnetostriktiv
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Basic safety instructions

2.6 Warranty and liability

The General Terms and Conditions ("Allgemeine Geschäftsbedingungen") of
TR-Electronic GmbH always apply. These are available to the operator with the
Order Confirmation or when the contract is concluded at the latest. Warranty and
liability claims in the case of personal injury or damage to property are excluded if
they result from one or more of the following causes:
 Non-intended use of the measuring system.
 Improper assembly, installation, start-up and programming of the measuring
system.
 Incorrectly undertaken work on the measuring system by unqualified personnel.
 Operation of the measuring system with technical defects.
 Mechanical or electrical modifications to the measuring systems undertaken
autonomously.
 Repairs carried out autonomously.
 Third party interference and Acts of God.

2.7 Organizational measures

 The other applicable documents must always be kept accessible at the place of
use of the measuring system.
 In addition to the other applicable documents, generally applicable legal and other
binding accident prevention and environmental protection regulations are to be
observed and must be mediated.
 The respective applicable national, local and system-specific provisions and
requirements must be observed and mediated.
 The operator is obliged to inform personnel on special operating features and
requirements.
 The personnel instructed to work with the measuring system must have read and
understood the Assembly Instruction, especially the chapter "Basic safety
instructions" prior to commencing work.
 The nameplate and any prohibition or instruction symbols applied on the
measuring system must always be maintained in a legible state.
 Do not undertake any mechanical or electrical modifications on the measuring
system, apart from those explicitly described in the other applicable documents.
 Repairs may only be undertaken by the manufacturer or a facility or person
authorized by the manufacturer.
 TR-Electronic GmbH 2007, All Rights Reserved
Page 36 of 51
TR-ELA-BA-DGB-0004 v16
Printed in the Federal Republic of Germany
03/17/2021

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis