Interruption Of Work Till 4 Hours - WAGNER WoodPerfect W 600 Originalbetriebsanleitung

GB
•
The spray movement should come from the arm, not just from the wrist. This ensures
that a uniform distance is maintained between the spray gun and the spray surface
during the spray operation. Select a distance of 5 - 15 cm, depending on the desired
spray jet width.
Fig. 8 a: CORRECT Even distance to the object.
Fig. 8 b: INCORRECT Uneven distance causes uneven coating.
•
Move the spray gun evenly cross-wise or up-and-down, depending on the spray
pattern setting.
•
An even movement of the spray gun results in an even surface quality.
•
When coating material builds up on the nozzle and air cap, clean both parts with a
solvent or water.

Interruption of Work till 4 Hours

•
Turn the machine off.
•
Insert the spray gun into the gun holder.
•
When processing 2-component varnishes, clean the device immediately.
Taking Out of Operation and Cleaning
Proper cleaning is the prerequisite for problem­free operation of the paint application
device. No warranty claims are accepted in case of improper or no cleaning.
1) Turn the machine off. Vent the container in case of longer breaks and after the work
has been terminated. This can be done by briefly turning open and then closing the
container or by pulling the trigger guard and letting the paint into the original paint
container.
2) Unscrew the container. Empty any remaining coating material back into the material
tin.
3) Preclean the container and feed tube with a brush. Clean the ventilating bore
(Fig. 11, A).
4) Pour solvent or water into the container. Screw the container back on.
Use only solvents with a flashpoint over 21 °C.
5) Turn on the machine and spray the solvent or water into a container or a cloth.
6) Repeat the above procedure until the solvent or water emerging from the nozzle is
clear.
7) Turn off the machine.
8) Screw of the container and empty it. Pull out the suction tub with container seal.
CAUTION! Never clean seals and nozzle or air holes of the spray gun with metal
objects.
9) Unscrew the union nut and remove the air cap and nozzle. Clean the air cap, nozzle
seal and nozzle with a brush and solvent or water (Fig. 11, 5).
10) Clean the outside of the spray gun and container with a cloth soaked in solvent or
water.
11) Assemble the parts again (see "Assembly").
18
W 600 WoodPerfect