Mounting Rules - TR-Electronic 65 Serie Gesamt-Bedienungsanleitung

Mounting rules

4 Mounting rules

 Secure the measuring wire during installation work.
 Do not pull out the measuring wire beyond the measuring range.
 Do not damage the measuring wire.
 Do not kink the measuring wire.
 Do not twist the measuring wire.
 Do not oil or grease the measuring cable.
 Do not pull the measuring wire at an angle.
 Do not allow the measuring wire to loop around objects.
 Attach the measuring wire to the object to be measured in a retracted position.
 Do not loop the measuring wire around body parts.
 Select the installation position in such a way that damage to and soiling of the
measuring wire is prevented.
 If possible, prefer an installation position with the measuring wire exit pointing
downwards. This prevents liquids from entering the measuring cable outlet.
 Do not allow the measuring wire to snap. Free return of the measuring wire is not
permitted!
 Only mount the measuring system with the mounting accessories provided for this
purpose.
 Guide the measuring wire in a protected area so that it cannot get caught or
otherwise damaged.
 For optimum rope guidance, the ring at the end of the measuring wire must be freely
movable. Therefore, do not clamp the rope end ring tightly, e.g. by means of a screw
or riveted connection.
 TR-Electronic GmbH 2022, All Rights Reserved
Page 34 of 40
Destruction, damage or malfunctions of the measuring system and
risk of physical injury!
 To avoid personal injury as well as damage and wear to the measuring
system, the following installation instructions must be strictly observed.
TR-ECE-BA-DGB-0170 v00
Printed in the Federal Republic of Germany
04/04/2022