Faults Table - ETNA A126VWRVS Anleitung

FAULTS

Faults table

FAULTS
There is a smell of gas in the
vicinity of the appliance.
A burner does not ignite.
If the appliance does not work properly, this does not always mean
that it is defective. Try to deal with the problem yourself fi rst by
checking the points mentioned below in the table or visit our website
www.hps.nl for more information.
CAUSE
A burner is turned on but
not lit.
The coupling on a bottled
gas unit has come undone.
Plug not in socket.
Fuse defective/fuse in meter
cabinet switched off.
Sparkplug dirty/damp.
Burner parts not correctly
installed.
Burner parts dirty/damp.
Main gas tap closed.
Fault in the gas network.
Control knob not kept
pressed in long enough or
far enough.
GB 10
Faults table
SOLUTION
Close the tap and wait
for a few minutes before
relighting.
Tighten the coupling.
Push the plug into the socket.
Fit a new fuse or switch the
automatic fuse back on.
Clean and dry the sparkplug.
Assemble the burner parts
using the centring ridges.
Clean and dry the burner
parts, making sure that the
outfl ow holes are open.
Open the main gas tap.
Check with your gas supplier.
Keep the control knob
pressed in far enough
between full and low.