Scheppach 4906806000 Anleitung Seite 23

Table and pillar, Fig. 3
1 Slide the drilling table (3) onto the pillar (2). Position
the table directly above the base plate.
2 Install the table bolting (b) in the table unit from the
left side and tighten it.
Machine head and pillar, Fig. 4
1 Place the machine head (4) onto the pillar (2).
2 Put the spindle of the drilling machine with the table
and the base plate in the cover and fasten the 2 Al-
len screws (c).
Drill chuck protection, Fig. 5
Fit the chuck protection (10) onto the spindle pipe and
fasten the slotted screw (d).
23