Maintenance - Scheppach 4906806000 Anleitung

switch on, bring the drill down to the workpiece lining it
up with the hole location.
Turn the switch on and pull down on the feed handles
with onIy enough effort to allow the drill to cut.
FEEDING TOO SLOWLY might cause the drill bit to burn.
FEEDING TOO RAPIDLY might stop the motor, cause the
bett or drill to slip, tear the workpiece loose, or break the
drill bit.
When drilling metal, it may be necessary to lubricate the
tip of the drill with motor oil to prevent burning the drill
bit.
Turning on the laser light Fig. 12
Turn on laser light (L)
Laser (M)
Working with the laser Fig.13
Align the illustrated borehole in the focal point (F) of the
laser, place the drill and begin drilling.
Battery replacement Fig. 14:
Push button at the bottom and remove
Replace the batteries and put lid back

Maintenance

WARNING:
For your own safety, turn the switch off and remove plug
from power source outlet before any operation of mainte-
nance on our drill press.
Keep your appliance clean.
Be careful some household cleaning products and sol-
vents such as benzine, trichloroethene, chloride, ammo-
nium, etc., can damage plastic parts.
To avoid motor darnage, blow out or vacuurn frequently
this motor to keep drill press dust from interfering with
normal motor ventilation.
33