Installation - Agilent Technologies Turbo-V 1000 ICE Bedienungshandbuch

Installation

The Turbo-V controller is equipped with a 3-wire power cord and plug
WARNING!
(internationally approved) for user safety. Use this power cord and plug in
conjunction with a properly grounded power socket to avoid electrical shock.
High voltage developed in the controller can cause severe injury or death.
Before servicing the unit, disconnect the input power cable.
The Turbo-V controller can be used as a bench unit or a rack module, but it must
NOTE
be positioned so that free air can flow through the holes. Do not install or use
the controller in an environment exposed to atmospheric agents (rain, snow,
ice), dust, aggressive gases, or in explosive environments or those with a high
fire risk.
During operation, the following environmental conditions must be
respected:
To connect the controller to the pump use the specific cable supplied
with the controller.
See the appendix "Technical Information" for detailed Information
about the above mentioned and the other connections, and about the
options installation.
Turbo-V 1000 ICE Controller User Manual / 87-900-905-01 (M)
temperature: from 0 °C to +40 °C;
relative humidity: 0 – 95 % (without condensation).
Instructions for Use

Installation

197/268
16