Setting The System - Waeco MagicWatch MWE9004 Montage- Und Bedienungsanleitung

MagicWatch MWE9004, 9008
8

Setting the system

See fig. f to fig. h
A
NOTICE!
Incorrect settings can impair safe operation.
I
NOTE
To stop setting the parameters without saving your changes, or
to stop the entire set-up: refrain from pressing any buttons for a
while.
The control electronics for the front sensors have the following control
elements:
No. in fig. f
1
2, 3
Setting the values
See fig. g to fig. h.
Configuring the front control module (MWE9008)
 You can set the travel speed at which the sensors switch off by connect-
ing the control electronics of the front sensors to the speedometer.
➤ Set parameter 11 to the required value.
 You can set a switch-off time for the front sensors if you are unable to con-
nect the control electronics of the front sensors to the speedometer (e.g.
no speedometer signal or signal via a CAN bus adapter such as CBI150).
➤ Set parameter 12 to the required time.
 You can set the system so that the front sensors not only display obsta-
cles intermittently but all the time until they are deactivated by the travel
speed or by switching off.
➤ Set parameter 16 to 1.
 You can set the sensitivity of the sensors.
➤ Set parameter 17 to the required value. 1 = low; 2 = medium; 3 = high
EN
Designation
Display
F5
C5
Buttons for setting the system
Factory settings activated
Your own settings
Setting the system
27