Troubleshooting Guide - Kenwood KWL90 Bedienungsanleitung

Troubleshooting Guide

Problem
The whisk, K-beater or
ceaming beater knocks
against the bottom
of the bowl or not
reaching the ingredients
in the bottom of the
bowl.
Slow speed attachment
cannot be fitted.
The Kitchen Machine
stops during operation.
Display shows error
message E27.
No power to appliance
/display screen not
coming on.
Appliance not
operating.
Timer not counting
down on display
screen.
Cause
Tool at the wrong height
and needs adjusting.
Check your attachment is
compatible for use with
your model.
Twist connection system
required (Model KAX)
Overload protection or
overheat system activated.
Maximum capacity
exceeded.
Appliance not plugged in.
On/Off switch not
operated.
Appliance has gone into
standby mode.
Control dial not pressed.
During the heating stage
of a preset, the timer will
not count down until the
correct temperature is
reached.
15
Solution
Adjust the height using a
suitable spanner – see "Tool
Adjustment" section.
Attachment must have the KAX
twist connection system
fit the outlet.
If you own attachments
featuring the Bar Connection
System you will need to
use the KAT002ME adaptor
to connect these to the Twist
Connection System on your
Stand Mixer.
For more information visit
www.kenwoodworld.com/twist.
Unplug and check for
obstruction or overloading.
If the machine will not operate,
remove some of the ingredients
to reduce the load and restart.
If this still does not resolve the
problem, unplug and allow to
stand for 15 minutes. Plug in and
restart.
If the machine does not restart
following the above procedure
contact " Customer Care" for
further advice.
Check appliance plugged in.
Press the On/Off switch to the
On position.
Touch the display screen or
rotate the control dial.
Press the control dial to start.
Normal operation.
to