Warranty - T.I.P. HWW 6000 EPF Original-Gebrauchsanweisung

Translation of original operating instructions
Malfunction
4. The pump stops be- 1.
cause the anti-dry- 2.
running feature is acti-
vated (red "Fehler"
(Error) indicator lights
up).
5. The pump cuts in and 1.
out too frequently.
2.
6. The pump does not 1.
cut out. 2.
7. The pump does not 1.
reach the desired
pressure.
2.
3.

10. Warranty

The present device was manufactured and inspected according to the latest me-
thods. The seller warrants for faultless material and workmanship in accordance
with the legal regulations of the country in which the device was purchased. The
warranty period begins with the day of the purchase and is subject to the provi-
sions below:
Within the period of warranty, all defects which are to be attributable to defective
materials or manufacturing will be eliminated free of charge. Any complaints are
to be reported immediately upon their detection.
The warranty claim becomes void in the case of interventions undertaken by the
purchaser or by third parties. Damage resulting from improper handling or opera-
tion, incorrect setting-up or storage, inappropriate connection or installation or
Acts of God or other external influences are excluded from warranty.
Parts being subject to wear and tear, such as the pump wheel (impeller) and me-
chanical shaft seals are excluded from warranty.
All parts were manufactured using maximum care and high-quality materials and
are designed for a long lifecycle. It should be understood, however, that the wear
and tear depends on the kind of use, the intensity of use and the internals of
maintenance. Complying with the installation and maintenance information con-
tained in the present operating instructions will therefore considerably contribute
to a long lifecycle of these wearing parts.
In case of complaints, we reserve the option of repairing or replacing the defec-
tive parts or replace the entire device. Replaced parts will pass into our property.
Claims for liquidated damages are excluded unless they are caused by willful
acts or negligence on the side of the manufacturer.
Possible Cause
Refer to section 2.2. + 2.3.
The flow rate is extremely low (< 250 l/h).
Permanent loss of very small quantities of
liquid (e.g. dripping water tap, leaking hoses
or connecting elements).
Electronic pump control is defective.
Permanent loss of large quantities of liquid.
Electronic pump control is defective.
Large suction height, see also 2.2
Refer to section 2.2.
Worn pump wheel.
1. Refer to section 2.2. + 2.3.
2. Operate consumers corresponding to the pump
capacity
1. Eliminate leakages.
2. Please contact the customer service depart-
ment.
1. Eliminate leakages.
2. Please contact the customer service depart-
ment.
1. It must be considered that the given suction
height have to be deducted from the max.
reachable delivery height.
2. Refer to section 2.2.
3.
Please contact the customer service depart-
ment.
16
Elimination
35