Fill In The Pump Housing - T.I.P. HWW 6000 EPF Original-Gebrauchsanweisung

Vorschau ausblenden

Inhalt

Inhaltsverzeichnis

Verfügbare Sprachen

Translation of original operating instructions

Prior to putting the pump into operation for

the very first time, the pump housing should

be fully vented - i.e. filled with water - even in

the case of self-priming units. If this venting

is omitted, the pump will not suck in the liquid

to be discharged. It is highly recommenda-

ble, yet not mandatory, to vent the intake line

as well, i.e. to fill it with water.

Dry-running - i.e. operating the pump without discharging water - is to

be avoided since the absence of water may cause the pump to run hot.

This may cause considerable damage on the device. Moreover, this

means that very hot water will be enclosed within the system so that

there is a hazard of scalding. If the pump has run hot, please pull off

the mains plug and allow the system to cool down.

Please do not expose the pump to moisture (e.g. when operating

sprinklers). Do not expose the unit to rain, either. Make sure that no

dripping connections are located above the pump. The pump should

not be used in wet or moist environments. Make sure that the pump

and the electrical plug connections are arranged in a flood-proof place.

The pump must not be running with the feeder line closed.

As long as the device is connected to the electrical mains, one must

never reach with one's hands into the opening of the pump.

Each time the pump is put into operation, please make sure that the pump is set

up securely and firmly standing. The unit must always be positioned upright on

an even surface.

Please inspect the pump visually prior to each use. This applies in particular to

the mains connection line and the mains plug. Make sure that all screws are firm-

ly tightened, and verify the perfect condition of all connections. A damaged pump

must not be used. In any case of damage, the pump has to be inspected by qual-

ified service staff.

7.1.