Safety Notes - Westfalia WFF760 Originalanleitung

Please note the included General Safety Notes and the following
safety notes to avoid malfunctions, damage or physical injury. Please
also observe the safety notes in the manuals for battery and charger.
▪ Please read this manual carefully and use the device only according to these
instructions.
▪ When operating the device, use protective equipment including goggles and hearing
protection. Depending on the task to be performed, wear respiratory protection. If the
operation of the device causes discomfort or discomfort, stop the work immediately and
get to the bottom of the cause.
▪ Dispose of unnecessary packaging material or store it in a place inaccessible to children.
There is a risk of choking!
Safety instructions for biscuit jointer
▪ Persons with impaired physical, sensory or mental abilities may not use the device
unless they are supervised and instructed by a caregiver.
▪ Keep the milling machine out of reach of children. The item is not a toy.
▪ Wood dusts can be harmful to health. Protect yourself with a dust mask.
▪ Check the flatdowel milling machine and electrical connections for damage and do not
use the flatdowel milling machine if the machine has been damaged.
▪ Use the flatdowel milling machine in accordance with these operating instructions and
only for the intended area of application for processing only wood.
▪ Clamp the workpiece with a clamping device or vice to prevent it from slipping. Always
hold the Flachdbad milling machine firmly with both hands when working. Always make
sure to stand safely.
▪ Protect the flatdowel milling machine from penetrating moisture and do not immerse
the machine in water or other liquids.
▪ Before immersion in the workpiece, the milling cutter must have reached full speed.
▪ Attention: Consider the running time of the machine after switching off. Always let the
machine come to a standstill before lifting it off the workpiece.
▪ Do not work with excessive pressure on the device. The best results can be achieved
with not too high a feed.
▪ Make sure that there are no foreign objects such as nails, screws, etc. in the material.
Never mill against nails or screws.
▪ Check the workpiece carefully and remove all nails and screws.

SAFETY NOTES

15