Philips 9000-Serie Bedienungsanleitung Seite 44

English
46
Problem
The appliance has a lower
suction power than usual.
The microfiber brushes do
not turn anymore
The microfiber brushes pop
out.
The appliance is not
charging.
When I use my vacuum
cleaner I sometimes feel
static electricity shocks.
Possible cause
The water channel of the wet
module and/or AquaSpin
nozzle is polluted or blocked.
The mesh in the dirty water
tank was not dry enough
before being used again.
Hair entanglement on the
microfiber brushes.
The dirty water tank is not
placed correctly.
The microfiber brushes are
clogged with hair or dirt.
The microfiber brushes are not
locked correctly.
The power plug is not
connected properly to the
socket or the adapter is not
inserted into the wall socket
properly.
The battery is not in.
The battery is not completely
inserted.
Wrong adapter connected.
Your vacuum cleaner builds up
static electricity. The lower the
air humidity, the more static
electricity the appliance builds
up.
You vacuumed up dust and
dirt. This also causes static
electricity.
Solution
that could block the wheel(s). Put the
appliance upright again and resume
cleaning.
Use the cleaning brush and clean the water
channel of the wet module and/or
AquaSpin nozzle (see 'Removing blockages
from the Vacuum & Mop set-up').
Clean and dry the dirty water tank.
Switch the appliance off and remove the
hair from the microfiber brushes (see
'Cleaning the AquaSpin nozzle').
Place the dirty water tank into the
appliance properly (see 'AUTOCLEAN after
every use'). It is closed correctly when you
can hear a 'click' sound.
Clean the microfiber brushes with a pair of
scissors or by hand (see 'Cleaning the
AquaSpin nozzle').
Place the microfiber brushes back in the
right position and lock them.
Make sure that the power plug is
connected properly to the socket and that
the adapter is inserted into the wall socket
properly.
Please insert the battery.
Please insert the battery until you hear a
click sound.
Please use the original adapter.
If you have checked the above and the
appliance still does not charge, take it to a
Philips service center or contact the
Consumer Care Center.
Make sure to touch the metal pin with your
hand while holding the appliance.
Make sure to touch the metal pin with your
hand while holding the appliance.