Philips 9000-Serie Bedienungsanleitung Seite 41

Problem
There is no water on the
floor.
There is more water on the
floor or in the After-Clean
tray than usual.
The appliance leaves water
traces on the floor.
Possible cause
The clean water tank is empty.
The wetting strips are blocked.
The water channel of the wet
module and/or AquaSpin
nozzle is polluted or blocked.
The dirty water tank is not
placed correctly.
You have moved the appliance
sideways.
You made strong turns with
the appliance.
You have lifted the appliance
over a threshold, carpet or
stairs.
Solution
wetting strips of the AquaSpin nozzle'). If
that does not help, you can try to carefully
open the holes with a needle.
Refill the clean water tank.
Remove the two microfiber brushes, fill the
clean water tank with some water, and
switch the appliance on. Make small
forward and backward movements on the
same position for around 15 seconds. You
should be able to see four water stripes on
the floor. If this is not the case, or if one or
more water stripes only consist out of a few
droplets, the wetting strips are partially or
fully blocked and you can rinse them under
the tap (see 'Clearing blockages from the
wetting strips of the AquaSpin nozzle'). If
that does not help, you can try to carefully
open the holes with a needle.
If you have checked the above and there is
still no water on the floor, take the
appliance to a Philips service center or
contact the Consumer Care Center.
Use the cleaning brush and clean the water
channel of the wet module and/or
AquaSpin nozzle (see 'Removing blockages
from the Vacuum & Mop set-up').
Place the dirty water tank into the
appliance properly (see 'AUTOCLEAN after
every use'). It is closed correctly when you
can hear a 'click' sound.
To prevent water traces on the floor, try to
make less strong turns with your AquaTrio
9000 Series and avoid moving the
appliance sideways.
To prevent water traces on the floor, try to
make less strong turns with your AquaTrio
9000 Series and avoid moving the
appliance sideways.
After you switch off the appliance, move it
forwards and backwards a few times to
remove the liquid that is present between
the two microfiber brushes. If you switch
off the appliance and lift it up immediately
afterwards, the water that was present
between the brushes leaves a trace of
water on the floor.
English
43