Operation; Disposal And Recycling; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL MSS 1608 Originalbetriebsanleitung

•
Caution! Guide in the socket head screws
(15, 16) from above. This avoids any risk of
injury due to protruding screws.
•
The mounting method on the base frame will
need to be adapted depending on the design
of your device. Check the example images 11
- 13 for more information.
5.3 Adjustment of the supporting rollers
(Fig. 5)
The height of the supporting rollers must be set to
the work table height of the device. To do this, sla-
cken the locking grip (item 9), adjust the height of
the supporting rollers for the relevant device and
then retighten the locking grip.
Warning! The supporting rollers must not be set
any higher than the work table height of the de-
vice. This could lead to jamming of the saw blade
or of the material being cut.
It is also possible to adjust the width of the sup-
porting rollers. To do this, slacken the locking grip
(item 4), adjust the supporting rollers based on
the length of the workpiece and then retighten the
locking grip again.

6. Operation

Warning! Before switching on the device, make
sure that the clamping device (item 1), supporting
rollers (item 10), and the screws (item 15 / 16) are
fastened securely. Never operate the device if it is
not in a stable position. Make sure that the base
frame is stood securely. Make sure that all the feet
are properly latched in position.
For instructions on operation of the relevant
device, please refer to the original operating inst-
ructions and safety information included with the
device.
7. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before star-
ting any cleaning work.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
Anl_MSS_1608_SPK13.indb 14 Anl_MSS_1608_SPK13.indb 14
GB
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
7.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
7.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.Einhell-Service.com

8. Disposal and recycling

The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
The reprinting or reproduction by any other me-
ans, in whole or in part, of documentation and
papers accompanying products is permitted only
with the express consent of the Einhell Germany
AG.
Subject to technical changes.
- 14 -
11.10.2021 10:03:18 11.10.2021 10:03:18