Safety Regulations; Layout And Items Supplied - EINHELL MSS 1608 Originalbetriebsanleitung

Danger!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.
Explanation of the symbols used (see Fig. 15)
1. Danger! - Read the operating instructions to
reduce the risk of injury.
2. Caution! Wear ear-muff s. The impact of noi-
se can cause damage to hearing.
3. Caution! Wear a breathing mask. Dust
which is injurious to health can be generated
when working on wood and other materials.
Never use the device to work on any materi-
als containing asbestos!
4. Caution! Wear safety goggles. Sparks ge-
nerated during working or splinters, chips and
dust emitted by the device can cause loss of
sight.
5. Caution! Risk of injury! Do not reach into
the running saw blade.

1. Safety regulations

Warning!
Read all the safety information, instructions,
illustrations and technical data provided on
or with this power tool. Failure to adhere to the
following instructions may result in electric shock,
fi re and/or serious injury.
Keep all the safety information and instruc-
tions in a safe place for future use.
The base frame must be placed on a fl at and
clean surface. Whenever you use this crosscut
saw base frame, always secure the device with all
four screws. Do not exceed the maximum permis-
sible load for the base frame. Observe the general
safety principles for woodworking equipment.
Follow the original operating instructions and the
safety information for the device used in combina-
tion with the base frame.
Anl_MSS_1608_SPK13.indb 12 Anl_MSS_1608_SPK13.indb 12
GB

2. Layout and items supplied

2.1 Layout (Fig. 1-3, 7)
1. Clamping device
2. Guide rails
3. Arm
4. Locking grip for arm
5. Clamp lever
6. Foot
7. Extension plate
8. Transverse lock
9. Locking grip for supporting roller
10. Supporting roller
11. Securing bracket
12. Adjusting screw
13. Lock nut
14. Lock bolt
15. Socket head screw (short)
16. Socket head screw (long)
17. Washer, large
18. Washer, small
19. Spring washer
20. Nut
2.2 Items supplied
Please check that the article is complete as
specifi ed in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made your purchase at
the latest within 5 working days after purchasing
the product and upon presentation of a valid bill
of purchase. Also, refer to the warranty table in
the service information at the end of the operating
instructions.
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
Danger!
The equipment and packaging material are
not toys. Do not let children play with plastic
bags, foils or small parts. There is a danger of
swallowing or suff ocating!
•
Base frame
•
Clamping device (2x)
•
Locking grip for arm (2x)
- 12 -
11.10.2021 10:03:18 11.10.2021 10:03:18