R911344640 / 01
|
Simulator PRC7000
7.2.2
Connection for programming terminal
XFU0 (USB interface)
Point-to-point connection of the programming terminal (PC/laptop with
software PRC7000 for administration, diagnosis, archiving, backup).
The Ethernet connection XFE0 can be used for networking, refer to
page 165.
Connection with simulator PRC 7000.xxx, refer to page 182.
Connection:
Cable length:
Bosch Rexroth AG
on USB type B connector
max. 3 m
201 / 256
Assembly