Before First Use; Accessories; Operation; Adjusting The Base Plate - Parkside PFS 710 E4 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

˜ Before first use
˜ Accessories
To operate this product safely and correctly, the
following accessories, i .e . tools and saw blades,
are necessary:
Suitable saw blade
¾
Accessories and saw blades are available
through your authorised dealer . When buying
always consider the technical requirements of this
product (see "Technical data") .
If you are not certain, ask a qualified specialist
and get advice from your trusted dealer .
NOTE
This instruction manual contains
u
information and suggestions for several
saw blades and their uses . The saw blades
depicted are not necessarily included in
the shipment, but are meant to indicate
additional possibilities for using this
product .
˜ Operation
˜ Adjusting the base plate
(Fig . B)
m
WARNING!
Always switch the product off,
disconnect it from the mains and let the
product cool down before making any
adjustments!
14 GB
m
CAUTION! RISK OF INJURY!
Saw blades can be sharp and become
hot during use . Always wear protective
gloves when handling saw blades .
m
CAUTION! RISK OF INJURY!
Remove the saw blade from the product
u
before adjusting the base plate 5
(see "Inserting/removing the saw blade") .
Do not use the product without having
u
inserted the base plate 5 .
To adapt to the workpiece, the base plate 5 can
be adjusted and swivelled to different positions .
Unlock the base plate 5 : Turn the locking
¾
lever (base plate) 1 in a counter-clockwise
direction .
Adjust the desired position of the base plate
¾
5 by pushing it in or pulling it out .
Lock the base plate 5 : Turn the locking lever
¾
(base plate) 1 in a clockwise direction until
it locks into place .
˜ Turning the rear handle
(Fig . C)
If necessary, the rear handle 9 can be rotated
90° to the right or left to improve your working
position .
Press the lock button (handle) 8 .
¾
Turn the rear handle 9 to the right or left .
¾
Release the lock button (handle) 8 .
¾
Engage the rear handle 9 at one of the
¾
3 position arrows ( 7 ) .