Inhaltsverzeichnis
Werbung
5. Remove the transportation protection
device:
Unscrew the screwed on parts.
Fig. 5/1
Remove the glued on transportation
protection devices. Fig. 5/2
Hold the plastic part, do not press
on it. Take hold of the tab and slowly
pull out the strip straight and parallel
to the base.
6. Insert the enclosed cavity fixture,
Fig. 6/1, into the housing.
Adjust the profiled strip, Fig. 6/2,
to the inside height of the high sided
unit and glue to the housing on the
door opening side.
If the side panels of the high sided
unit are 16 mm (or thinner), separate
the enclosed spacers, Fig. 6/3, and
insert into the hinge arms.
7. Push the appliance into the
high sided unit until the stop bar
at the top, Fig. 7/1, and the stops
on the door hinges, Fig. 7/2, are
situated on the front edge of the
high sided unit. Move the hinge side
of the appliance right up to the side
panel of the high sided unit.
8. Screw the appliance to the side,
Fig. 8/1, to the top, Fig. 8/2,
and to the bottom, Fig. 8/3,
of the high sided unit.
Insert the caps. Fig. 8/4
Attach the door handle
To prevent damage, the door handle
is enclosed loosely with the appliance.
Press rubber seal to the side,
Fig. 8/5, connect the handle,
Fig. 8/6, and screw tightly. Fig. 8/7
9. Loosen the screws, Fig. 9/1, and
align the door. Retighten the screws.
Push the caps, Fig. 9/2, onto the
hinges.
Electrical connection
The socket should be freely accessible,
preferably above the high sided unit.
Do not operate the appliance until it has
been installed.
When sliding the appliance into the
high sided unit, do not pinch the power
cord.
Connect the appliance to 220 240 V/
50 Hz alternating current via a correctly
installed earthed socket.
The socket must be fused with a 10 to
16 A fuse. If the appliance is to be
operated in a non European country,
check on the rating plate whether the
indicated supply voltage, current type and
frequency of the appliance correspond
with the specifications of your power
supply. The rating plate is situated in the
bottom left hand side of the appliance.
The power cord may be replaced
by an electrician only.
Installation dimensions
Fig. 0
de
en
7
Werbung
Inhaltsverzeichnis
