Inhaltsverzeichnis
Werbung
de
en
Installation
Please detach the illustrated centre pages
before reading the installation instructions.
You can now read the text in conjunction
with the illustrations.
Installation location
Install the appliance in a dry, well
ventilated room. The appliance should
not be installed in direct sunlight or near
a heat source (e.g. radiator, cooker).
If required, use an insulating plate
or observe the following minimum
distances from the heat source.
3 cm to an electric cooker.
From an oil or solid fuel cooker 30 cm.
6
Installing the appliance
A Torx T20 screwdriver is required
for installation.
The required fixtures are enclosed with
the appliance.
Important!
To protect the glass door, do not remove
the transportation protection devices
until the appliance has been placed in
the cavity. Fig. 5
If installing the appliance in a room divider,
line the rear of the installation cavity in the
area of the appliance.
1. Carefully align the high sided unit with
a spirit level. Fig. 1/1 The high sided
unit must be screwed securely
to the adjacent units, Fig. 1/2,
or to the wall. Fig. 1/3
2. The appliance must be ventilated by
an opening in the base and a duct at
the rear of the high sided unit. Fig. 2
Minimum cross section of the
ventilation openings in the base
and duct: 200 cm
3. Install the power cord and pull into
the required position with a piece
of string, ensuring that the socket
is accessible after the appliance has
been installed. Slide appliance into
the high sided unit. Do not trap the
power cord. Fig. 3
4. When the door is open, insert the
cover strip into the sheet metal
brackets on the housing. Fig. 4/1
Screw on the cover strip with the
enclosed screws. Fig. 4/2
2
.
Werbung
Inhaltsverzeichnis
