Prescanning/Scanning The Slides Continuously; Setting On Feeder Window - Sony UYA-S290SF Bedienungsanleitung

Prescanning/Scanning the Slides Continuously

Setting on Feeder Window

Mode
8
(GB)
To prescan/scan the slides continuously, use the auto slide feeder.
This section explains the operations related to the auto slide feeder only.
For the other operations, refer to the software manual of the UY-S90 film
scanner.
Note
For using the auto slide feeder, the film scanner firmware should be
version 2.01 or later, and the software should be version 4.0 or later. The
required firmware and software are included in the supplied CD-ROM.
For version upgrade, refer to "Readme" in the CD-ROM.
Slide mounts applicable to the auto slide feeder
Mount your slides on the following slide mounts.
• Slide mount of 1 to 2.5 mm (
• Plastic mounts recommended
• Paper mount whose edge is broken or curled is not suitable.
Some slide mounts cannot be used even if they meet the above conditions.
The Feeder window appears only when the auto slide feeder is connected
to the film scanner.
Feeder window
Prescan only first slide (No limit): Prescans and previews the first slide
set on the auto slide feeder only. Adjust the preview image appropriately
and start scanning. The other slides on the auto slide feeder are scanned,
without previewing, under the same conditions adjusted for the first slide.
You can stop scanning temporarily using the Pause button displayed
during scanning to add slides to the auto slide feeder.
Prescan all slides (50 slides max): Prescans up to 50 slides set on the
auto slide feeder continuously. After prescanning, all the frames are
previewed. You can adjust frames as required and select the frames for
scanning.
1 1
/ to / inch) thickness
16 8