Handle; Protectic Caps - Bosch DCU 130 Instandsetzungsanleitung

en 20 | DCU 130 | Repairs
6.6

Handle

Dismantling
¶
Remove the screws from the handle (1).
Replacing the component
1. Remove old handle.
2. Insert new handle.
Fitting
¶
Assemble the tester by following these instructions
in reverse.
|
1 689 975 217 2011-06-07
6.7

Protectic caps

i
The protective caps are orderable as a spare part
kit. We recommend to exchange the complete kit of
parts particularly with old-conditional wear.
Dismantling
1. Remove the screws from the handle (1).
2. Remove the handle.
3. Remove the screws from the ventilation housing (2).
4. Remove the ventilation housing.
Replacing the component
1. Remove old protection caps (3).
2. Insert new protection caps.
Fitting
¶
Assemble the tester by following these instructions
in reverse.
Robert Bosch GmbH