Bosch DCU 220 Instandsetzungsanleitung Seite 22

en 22 | DCU 220 |
Replace the battery
Open cover on storage battery (
right side) that would need to be replaced.
1. Push the cover lock into "unlocked" position ( )
().
2. Push the cover upward ().
3. Open the cover.
Abb. 8: Storage battery 1 as an example
4. Pull on the ribbon to remove the storage battery
from the compartment.
5. Push the new storage battery completely into the
compartment with the labeling upward.
6. Push the storage battery lock all the way to the left
into 'locked' position ( ); make sure not to pull on
the ribbon.
Abb. 9: Completely lock the storage battery
7. Close the cover and push it downward until it locks
in place.
8. Then push the lock into 'locked' position ( ).
!
The lock can only engage if the cover is snapped
in. The lock must be securely engaged so that the
bottom, red part cannot be seen.
4.2.3 Replacing cover
i
Each of the covers is secured with two or four
screws to the underside of the DCU 220.
1. When necessary, push cover lock into 'unlocked'
position ( ).
2. Slide cover upward.
3. Open covers.
4. Remove screws from cover.
5. Remove cover.
|
1 689 975 264 2015-06-02
4.2.4
on the left or the 1. Remove five screws on the edge protector.
2. Remove edge protector.
4.2.5
Abb. 10: Remove the handle.
1. Remove the screws on every side.
2. Remover carrying handle.
4.2.6
1. Push latch upward and hold in position.
2. Remove the two screws below it.
3. Remove the locking piece.
Abb. 11: Replace the locking piece
4.2.7
1. Switch off the DCU 220.
2. Disconnect the DCU 220 from the power supply.
3. Push cover lock into 'unlocked' position ( ) ().
4. Slide cover upward ().
Abb. 12: Open the cover.
5. First pull the ribbon to the right and then forward to
6. Push new hard disk upward with silver side up com-
7. Close the cover and push it downward until it locks
8. Then push the lock into 'locked' position ( ).
!
Replacing edge protector
Replacing carrying handle
Replace the locking piece
Replacing the hard disk (SSD)
remove the hard disk from the compartment.
pletely into the compartment until it locks.
in place.
The lock can only engage if the cover is snapped
in. The lock must be securely engaged so that the
bottom, red part cannot be seen.
Robert Bosch GmbH