Service Setting Htd 8Xx - Bosch HTD 6 Serie Serviceanleitung

en 40 | HTD 6xx, HTD 8xx | Service setting HTD 8xx
4.

Service setting HTD 8xx

i
Various visualisation and measurement function
settings can be made in the Service menu.
1. Select "Service" in the Options menu.
2. The PIN input mask appears.
3. Enter the PIN: 835231
4. Select the desired option.
"
The mask with the selected option is displayed.
Page two of the Service menu can be accessed
with the key.
i
The test standard and device function can be set on
page two.
|
1 692 106 011 2014-06-23
i
The official test standard for the test requirements
can be selected with the test standard setting:
Test standard Description
ECE test
The device checks the headlamps
on the basis of the ECE (European)
standard
SAE test The device checks the headlamps
on the basis of the SAE (American)
standard
i
The purpose for which the device is to be used can
be selected with the device function setting:
Intended use Device function
Real
Use of device in workshop or
PTI organisation
Demo
Use of device for demonstration
purposes only
Lab Use of device for development
work
Tolerances
i
The tolerances to be used for headlamp assessment
are specified here.
1. Select "Options" in the start mask.
2. Select "Service" in the "Options" mask.
3. Enter the PIN: 835231
4. Select "Tolerances" in the "Service" mask.
5. The key is used to select the test standards for
which the tolerances are to be set.
$
ECE
$
SAE
$
VOR
$
VOL
6. The key is used to select the headlamps for
which the tolerances are to be set.
$
- Dipped beam
$
- Main beam
$
- Fog lamps
Robert Bosch GmbH