Zero Point And Laser Visor Htd 8Xx - Bosch HTD 6 Serie Serviceanleitung

en 36 | HTD 6xx, HTD 8xx | Checking / calibration
3.3

Zero point and laser visor HTD 8xx

1. Position the calibration triangle with the reference
mark centrally in front of the cross laser.
2. Position the beam setter behind the vertex of the
triangle.
3. Check the position of the spirit level in the light box.
In the event of deviation from the centre position,
perform any necessary adjustment with the screws on
the trolley.
4. Switch on the laser and align the vertical laser
line with the reference mark and the vertex of the
triangle.
|
1 692 106 011 2014-06-23
5. Align the centre of the lens with the laser cross and
the centre (hole) of the test screen with the vertical
laser line.
6. Centre the hole in the test screen with the laser lines.
7. Switch on the beam setter and click onto OPTIONS.
OPTIONS
8. Click onto SERVICE in the OPTIONS mask.
SERVICE
9. Enter 835231 as PIN.
XXXXXX
10. Click onto PREVIEW in the SERVICE mask.
Preview
Robert Bosch GmbH