Checking / Calibration; Zero Point And Laser Visor Htd 6Xx - Bosch HTD 6 Serie Serviceanleitung

en 34 | HTD 6xx, HTD 8xx | Checking / calibration
3.

Checking / calibration

3.1

Zero point and laser visor HTD 6xx

1. Position the calibration triangle with the reference
mark centrally in front of the cross laser.
2. Position the beam setter behind the vertex of the
triangle.
3. Check the position of the spirit level in the light box.
In the event of deviation from the centre position,
perform any necessary adjustment with the screws on
the trolley.
4. Switch on the laser and align the vertical laser line with
the reference mark and the vertex of the triangle.
|
1 692 106 011 2014-06-23
5. Set the inclination angle to "0" position with the dial
knob of the beam setter.
6. Align the centre of the lens with the laser cross and
the centre of the test screen with the vertical laser
line.
7. The horizontal line of the test screen must coincide
with the horizontal laser line.
8. Switch on the laser visor.
Align the laser line of the visor in parallel with the
9.
calibration triangle.
Robert Bosch GmbH