Operation; Operation Of The Blender; Operation Of The Grater - Westfalia K-650 Bedienungsanleitung

Before the first Use: Clean all parts (except for the motor unit) in hot soapy
water, rinse carefully and allow to dry. Clean the motor unit as necessary. Use
only a moist cloth to clean the motor unit, never immerse it in liquids of any kind.

Operation

Please Notice: Before attaching any attachment to the machine, make sure the
unit is turned off and unplugged from the power mains.
To avoid Injury: Do not touch the blades when handling the accessories, during
operation or on the assembled appliance.

Operation of the Blender:

The blender can only be used with the bowl (5) and a cover in place. The latch on
the lid must engage in the slot in the motor housing. Do not attach a tool in the
bowl. Do not use the blender together with other attachments.
1. Press the locking button (14) on the motor unit to open the cover of the
blender drive.
2. Attach the blender to the motor unit.
3. Insert the ingredients into the blender, attach the lid and lock it by turning. The
unit can not be operated without the lid. Do not fill the blender higher then to
the MAX marking. Close the central hole with the plug, which may also act as
a measuring cup.
4. Now plug the power plug into a suitable wall socket with dry hands and turn
the unit on. Use the speed dial (11) to set a suitable speed and operate the
unit until the desired consistency is reached. For the highest operating speed
press the Turbo button (10). When blending hot ingredients, please keep in
mind that under certain conditions hot material may be thrown up in the
blender.
5. Before pouring from the blender, detach the blender from the motor unit and
remove the lid.
Please Notice:
Operate the blender only with liquid or soft material. Ice cubes may be added.
Do not operate the unit with attached blender continuously for longer than 3
Minutes and allow it to cool down before the next use.

Operation of the Grater

First, assemble the grater attachment. Proceed like this: First, insert the shaft into
the disc in such a way that the slot in the shaft points towards the open sector in
Operation
10