Safety Precautions - Bosch HTD 6 Serie Originalbetriebsanleitung

Fig. 7: Inserting the light box in the sliding block
6. Fasten the light box to the sliding block with the
two bolts provided. The bolts must be fitted on the
underside of the light box as shown below.
Fig. 8: Securing the light box
1 Light box
2 Bolt
3 Sliding block
4 Column
7. Unpack the alignment laser, screw it to the mount
and tighten firmly in position. Use the hole in the
alignment laser for this purpose.
Fig. 9: Attaching the alignment laser
8. Remove the locking screw for the counterweight in
the bottom part of the column.
Robert Bosch GmbH
Product description | HTD 6xx | 23
"
This completes device assembly.
3.6

Safety precautions

¶
The device is only to be operated by authorised
personnel trained to do so.
¶
Never use the device in an explosive atmosphere.
¶
The working area must be dry and adequately
ventilated.
¶
Watch out for other people when moving the device.
¶
The headlamps are checked and adjusted with the
vehicle engine running. An exhaust gas extraction
system must be installed. The inadvertent inhalation
of carbon monoxide can cause serious health
problems.
¶
Avoid direct sunlight and do not operate the
headlight tester in the vicinity of hot objects (fires,
radiators etc.).
¶
Never leave the headlight tester standing in the rain
or in a particularly damp place, as this could damage
the electronics.
¶
Put a dust cover (optional extra) over the headlight
tester during lengthy periods of non-use.
¶
The headlight tester contains a battery. Heed the
corresponding battery handling instructions on the
product.
¶
If problems occur during operation, contact Bosch
customer service or an authorised service partner.
¶
Only use GENUINE spare parts. These can be
obtained from Bosch customer service or an
authorised service partner.
The use of parts from other manufacturers renders
the warranty invalid.
en
|
1 692 104 610 2015-01-14