Product Installation; Wiring - Philips WelcomeEye Connect Anleitung

5. PRODUCT INSTALLATION

Important notes and advice:
- To make the most of your intercom panel, we recommend con guring it (RFID, for 1 or 2
families, 1 or 2 intercoms, loudspeaker volume) before nal installation. To do this, a table
connection may be necessary to check that the settings are correct.
- If you test your product before installing it, ensure that you do not test it with the intercom
panel and the monitor in the same room to avoid the video doorphone emitting a shrill
noise (feedback).
- Do not expose the camera lens to direct sunlight or a re ective surface.
- We recommend running the cables through a protective sheath to protect them against
breakage and bad weather.
- For the WelcomeEye Connect version, to make the most of your monitor's Wi-Fi function,
we advise you to check that your Wi-Fi network is accessible from where it is installed.

1. Wiring

To avoid the risk of interference and malfunctions, do not run the videophone cable through
the same sheath as the electrical cables.
Warning: Do not double up the wires to increase their section.
a. Connecting the videophone (monitor, intercom panel and camera)
Wires to be used: two wires 0.75mm
- Make sure to connect the wires in accordance with one of the wiring diagrams depending
on the desired con guration.
- Refer to the label stuck to the back of the monitor and the back of the intercom panel.
- Con gure the switches on the back of the intercom panel as well as the monitor interface
according to the chosen con guration (see section 2 intercom con guration).
b. Connecting a gate motor
- The intercom provides a dry contact (without power) to be connected to the push button
control of the automatic opener.
- Connect it directly to terminals 5 and 6 at the back of the intercom panel (no need to
observe polarity).
- The opening function is only possible if the video of the respective intercom panel is
displayed.
c. Connecting a strike plate or electric lock
Important: The strike plate or electric lock that you are ordering must have a mechanical
memory. The strike plate current cannot exceed 1.1A.
- Connect it directly to terminals 7 and 8 at the back of the intercom panel (no need to
observe polarity).
- The opening function is only possible if the video of the respective intercom panel is
displayed.
GB5
with 80m length or two wires 1.5mm
2
WelcomeEye Connect / Touch / 11/17
with 120m length.
2