Troubleshooting - Westfalia ASSG 18 Originalbetriebsanleitung

Problem
Red and green LEDs
do not illuminate to
indicate the Battery is
correctly charging
Battery pack has low
Capacity
Trigger Switch does
not move
Reciprocating Saw
does not start when
Trigger Switch is
depressed

Troubleshooting

Possible Cause
Battery not correctly
connected to Charger
Charger not powered
Battery not being fully
charged.
Battery Pack has
been charged over
100 Times and
Capacity has started
to reduce
The Trigger Switch
Lock is in the middle
Position.
Battery completely
discharged
Defective Battery
Tool defective
27
Solution
Clean Battery Socket
of charger and battery
contacts and fully
slide on to Charger so
it clicks in a locked
Position
Recheck mains
Connection
Do not remove
battery until a full
charge is indicated.
This is normal for
Battery Packs,
contact Westfalia to
purchase a replace-
ment Battery Pack
Slide the Trigger
Switch Lock either
Side and hold it there
Recharge Battery or
replace with a fully
charged Battery.
Replace Battery
Contact the Westfalia
customer service