☞
Pin assignment of the DMX connection: Pin1 = earth / Pin2 = (-) / Pin3 = (+).
Never connect the earth pin GND to the casing earth of the effect light; this may result in interference in
signal transmission caused by ground loops.
b) Setting up a master-slave chain
The LED light system can be operated by control of a DMX controller or in a master slave chain. In that case, the
integrated controller of the master device controls the connected slave devices.
• Connect the DMX OUT (5) port of the master device to the DMX IN (4) port of the first slave device.
• Connect the DMX OUT (5) port of the first slave device to the DMX IN (4) port of the subsequent slave device.
• Proceed as described above with all remaining slave devices.
• Plug an XLR plug with a terminating resistor into the DMX OUT (5) port of the last slave device (as described in
section "Connection of a DMX Controller").
10. Connection of the pedal switch
• Plug the connection plug of the pedal switch into the connection for the foot switch (13).
• Secure the connections with the cap nut.
• Install the connection line of the pedal switch in the location from where you want to control the LED light system.
28