A) Setup With A Stand On The Floor; B) Ceiling, Wall Or Crossbeam Installation - Conrad 1302513 Bedienungsanleitung

a) Setup with a stand on the floor

Set up the stand so that the effect light is outside of the reach of persons in the area with their
hands.
The effect light must be sufficiently far from the ceiling or any other limitation areas to prevent
heat accumulation.
The stand must be set up on a stable and horizontal surface.
The connection cables must not be located in the public area and the stand must be secured
against tilting (e.g. by pulling at the cables).
The stand's base must be placed or locked outside of the public area.
The stand must not be placed in the area of escape routes.
• If you have not done so yet, plug the connection plugs of the individual LED spots into the respective closest con-
nections (14) at the housing. Secure the plug-in connections with the cap nuts.
• Fold the stand base open as far as possible and secure it with the clamping screw.
• Push the LED light system onto the stand with the stand holder (12).
• When the stand holder (12) has been pushed onto the stand completely, secure the connection with the enclosed
small knurled screw.
• Align the individual LED spots as desired and secure them with the respective knurled screws.
• Extend the stand to the desired height, push the safety pin into the corresponding bore in the stand, and fasten the
stand with the clamping screw.

b) Ceiling, wall or crossbeam installation

• If you do not want to set up the LED light system on the floor but instead wish to install it at the ceiling, the wall or a
suitable crossbeam system, attach the enclosed mounting brackets with the two large knurled screws to the threads
for the mounting brackets (11) at the side of the housing.
• Screw the mounting brackets to the ceiling, wall or a crossbeam system. The mounting material and accessories
used must be suitable for the attachment type and able to bear the load of the effect light.
• Use self-securing nuts or screws at the attachment points for attachment.
• Additionally secure the installation with a suitable and certified safety retention rope or safety net with a load carry-
ing capacity of 12 times that of the effect light. The safety retention rope or the net must be designed to support the
effect light in the event of failure of the main support system independently of the main attachment. The effect light
must be caught after free fall of no more than 20 cm if the main support system is defective.
26