Klarstein PURELINE Bedienungsanleitung Seite 22

EN
1
22
INSTALLATION OF WATER INLET AND OUTLET
Installation place
Place the machine on a fl at and stable surface.
1. Installation of inlet water T valve
Clean the installation area, close the inlet water valve, take apart the faucet or
angle valve, then connect the inlet water T valve, fi nally connect to the original
faucet or angle valve.
Attention: Connection of screw thread should be sealed with tape or 0 ring to
avoid leakage.
2. Connection of inlet water port:
Connect one side of PE pipe to the inlet water valve, and another side to the inlet
water port on the machine.
3. Installation of faucet
According to the required place of faucet, drill a Ø29-mm hole on the stainless
steel sink. Then fi x the faucet.
quick connector screw nut
4. Connection of drinking water port
Connect directly with the connecting rod of faucet,cut the 1 /4" PE pipe to a
suitable length, one side insert to the quick connector and the other side connect
to the port of drinking water on the machine.
5. Connection of drain water port
Take a suitable length of 1/4" PE pipe to connect with the port of drain water on
the machine.And connect another side to the drain line and fi x the PE pipe to avoid
drop.
6. Flush the cartridge
lnstall all the cartridges before fl ushing.
1. Flushing of PCT cartridge: After all the installation, turn on the purifi ed water
tap to fl ush PCT fi lter about 10-20 minutes until the water is clean, then turn
off the purifi ed water tap.
Attention
1. lf there is no water coming from the tap, please check the power supply.
pad big pad big iron plate