Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
18
OPERATION GUIDELINE
Getting Started
1.
Place the water filter and dispenser on a table, cabinet or flat surface.
2.
Take out the water tank, fill with tap water up to the MAX water level of the
water tank and put it in the device.
3.
Connect to the mains.
4.
The machine flushes the filter system and the pipeline automatically for 2
minutes. After rinsing, the water in the tank should be drained and then
refilled with tap water.
5.
The machine starts water production automatically. It can be used normally
after completing water production. The water needs to be changed once
during the whole water-making process to refill the internal purified water
tank.
6.
In order to maintain excellent water quality, it is recommended to press and
hold the "Wash" button for 3 seconds to manually rinse, preferably three
times.
Please ensure that you place a jar with a capacity of at least 900ml beneath the
water outlet to collect the flushed water.
Daily use
Start and stop water withdrawal
The water dispenser has 6 temperature levels to choose from. Press the „Honey",
„Milk", and „Normal" water buttons to dispense water directly. You can press the
other three buttons after unlocking by the release button.
Note: If you press any temperature button during water dispensing, the water
dispensing will stop.
Set water temperature for Hot function
When the lock is on, long press the "Coffee" key for 5 seconds to enter the set
temperature mode. Press the "Coffee" key to increase the set temperature by
1 °C, press the "Tea" button to set temperature down by 1 °C. The set temperature
range between 85 °C and 95 °C. The machine memories the set temperature.
Attention
1.
This device is equipped with a water overflow protection. When the amount of
output exceeds 500 ml, the water output will stop automatically.
To avoid scalding, do not put your hand under the water spout when you draw
hot water.
Werbung
